Home >> Plate Roller >> 3 Roller Bending Machine >> W11-6×2000 3 roller bending machine

Three roll plate bending machine

Three roll plate bending machine
W11-6×2000 3 roller bending machine

No.

Parameters

Specifications

1

Bending thickness

6mm

2

Bending width

2000mm

3

Steel plate yield limit

245Mpa

4

Min. Bending diameter(full load)

T6×B2000×Φmin380mm

5

Diameter of upper roller

Φ170mm

6

Diameter of lower roller

Φ160mm

7

Distance between center of two lower roller

260mm

8

Operation speed

4.5m/min

9

Main motor

5.5kw

10

Lifting transmission

Alloy worm gear and alloy nut

11

Frequency and voltage

380V, 60Hz, 3Phase

12

Weight (approximately)

2Ton

W11-6×2000 3 roller bending machine

Application

3 roller bending machine
W11-6×2000 3 roller bending machine

W11-6×2000 3 roller symmetrical bending machine mainly used for rolling sheet metal, it can make different size of cylinders.

Main structure and how it works.

Three roll plate bending machine working process

▀ Mechanical 3 roller symmetrical bending machine.

▀ The machine is composed by two main parts, there are working parts and transmission parts. Working parts include two lower roller and one upper roller with roller bearings. The lower roller is the capstan, the upper roller is driven roller. Height of upper roller can be adjusted freely. Besides, the transmission part contain main motor, reduction box, etc. 

▀ The main motor drive the main reduction box, and then the main reduction box drive the lower roller. Direction of rotation of the lower roller can be controlled by the main motor.

▀ Subsidiary motor drive the subsidiary reduction box, then the upper roller could perform vertical movement.

▀ Unloading equipment can help operater take out finished products.

Raw material of roller and processing technic

▀ Raw material: 45# forging steel

▀ Manufacturer: Hengrong form Wuxi(famous brand in China)

▀ Datum: certificate of raw material and other inspection report attached with machine.

▀ Processing technic: caststeel ingot → forged blank → normalization after forging → rough turning → heat treatment(hardening and tempering) → finish turning → hard facing.

▀ Requirement of heat treatment: hard facing depth≥3mm, hardness≥HRC45-50.5. Welded structure(including the frame, foundation and other steel structure)

▀ Processing technic of welded structure:

Purchasing inspection → steel plate pretreatment → cutting → edge preparation → welding → weld joint inspection → annealing treatment → rough machining → Vibratory stress relief → fine machining → surface derusting and corrosion prevention → topcoating(as required by customers).

►Technical requirements: we promise all welding structure must be Q235A, all specification can meet GB.

► Perfect welding without pore, crack, etc.

► Stress relief before machining.

Three roll plate bending machine
W11-6×2000 3 roller bending machine

Machine and package

▀ Main structure: upper roller and lower roller, main transmission device, balance device, frame and bearings.

▀ Electronic control system

▀ Lubrication system

▀ Accessories and other necessary parts.

▀ Technical documents attached with machine: electrical schematic, drawing for installation, instructions, certification, packing list.