Home >> Plate Roller >> 4 Roll Plate Roller >> W12-25×3100 4 roll plate roller

4 Roll Plate Bending & Rolling Machine

4 Roll Plate Bending & Rolling Machine
W12-25×3100 4 roll plate roller

No.

Items

Parameters

1

           Bending thickness

25mm

2

Max. Bending width

3100mm

3

Roller working length

3200mm

4

Asymmetric Rolling

T25*B3100*min950mm

(σs≤245MPa)

5

Symmetrical Rolling

T25*B3100*min1000mm

(σs≤245MPa)

6

Upper roller DIA

Ф410mm

7

Lower roller DIA

Ф400mm

8

Side roller DIA

Ф320mm

9

Side roller slant angle

        25°

10

Auxiliary motor power

37KW

11

Upper roller Max. Permissible load

190KN

12

Source of power

Hydraulic

13

Driving model of roller

Hydraulic motor and planetary transmission

14

Operating speed

5m/min

15

Voltage and frequency

380V, 3 phase, 50Hz

16

Max. Working pressure of hydraulic system

19.5Mpa

W12-25×3100 4 roll plate roller

Specification

►The machine belongs to 4 Roll Plate Bending Machine ( 4 Roll Plate Roller ), used for cylinder pressure vessel manufacturing industries, it has function of roll round, pre-bending, correct the circle, with coarse leveling function.

4 roll plate roller
4 roll plate roller

►The upper roller is the main transmission, leading the lower roller and the side roller move by friction between the sheet plate and the upper roller, meanwhile, the upper roller provides torque for rolling rollers.

►The upper roller is the active roller by hydraulic transmission, lower roller and the accessories, both sides turn plane and supporting roller lifting are driven by hydraulic pressure.

►The lower roller use vertical lifting, the side roller use tilt lifting, so the synchronization precision error is less than 0.15mm.

►To make prebending, the lower roller rising and clamping the sheet plate, the side roller inclined upward, plate end pre-bending done.

►According to the arrangement of the side roller to adjust the position of the two sides, four roller rolling machine can do symmetric or non-symmetric bending, so the machine can be a rolled ideal very small arc straight edge into theory of surplus. If compared with the symmetrical three roller bending machine, four roller rolling machine do not need to use pre-bending plate press any more.

►The lubricating point of the machine use cut-up arrangement.

4 roll plate roller
4 roll plate roller

►The four-roller rolling machines’ control system adopted Japan OMRON intelligent high-speed PLC industrial control machine, the system can control lower roller, and the other roller accessories.►The lower roller and the two side roller’s displacement sensor using encoder, so the action design of the sensor is reasonable, which can guarantee the service life.

4 roll plate roller
W12-25×3100 4 roll plate roller

►All bearings used in the four-roller rolling machine are required to adopt the most advanced technology, the most well-known manufacturers of leading products.

4 roll plate roller
4 roll plate roller

►Hydraulic cylinder with accuracy manufacturing, good sealing effect, so the cylinder reduce the pressure relief and leakage of sealing device, in addition, all sealing accessories imported from abroad.

4 Roll Plate Bending Machine
W12-25×3100 4 Roll Plate Bending Machine